Getting started with RT-Thread on the CH32V307

I just received a WCH CH32V307 RISC-V development board as part of the Hack It! RISC-V Design Challenge. What follows is a simple tutorial in getting started with running an RT-Thread example on the CH32V307 development board.

Installing and setting up the IDE

Setting up the debugger

Setting up debug options in MounRiver Studio

Running the example

Screenshot of Run As

If all goes well, it should build and and start running the example. If not, you may need to click Project-> Rebuild. Now, open up rt-thread/user/main.c in the project, and you'll see that it is supposed to flash an LED and print to the terminal. Now you may wonder: “Why am I not seeing LED1 flashing on the board?” I wondered this too, and found this in the CH32V307 evaluation board manual:

  1. LED: Controlled by connecting the extension connector J3 to the IO port of the master MCU

What this actually means is that you need a jumper cable to connect pin LED1, which is on the extension connector J3, to pin PA0, which is on both the extension connector and the Arduino interface. If you wire this up correctly, you'll hopefully see the LED blinking:

Blinking LED on CH32V307 dev board

If you also want to see the RT-Thread terminal, just connect to the board using your favourite serial terminal at 115200 bps, e.g. using minicom:

minicom -b 115200 -D /dev/ttyACM0

RT-Thread terminal in minicom

You don't need a separate USB-serial adapter, as the serial interface is provided by the WC-Link onboard the development board.

Any feedback and comments are appreciated!

#riscv #wch #electronics #ch32v307 #rtthread